How To Replace Water Pump And Save Big || Jeep Mods E22
Fixing a coolant leak on our Jeep and how to remove and inspect our water pump. Here we remove the fan, fan shroud after draining all the coolant for our jeep. We go over how to remove the serpentine belt and were the tensioner is. Then we remove the power steering pump and the brackets that hold the power steering pump to give us clear access to the water pump. Finally, we pull the water pump, inspect the bearings and the weep hole for any issues that would have caused our coolant leak. Water Pump and Gasket: https://amzn.to/322dRvz Gasket Maker: https://amzn.to/2SnX8iM 1:10 Checking our radiator cap seal and spring pressure. 2:33 How to remove the mechanical radiator fan and fan shroud on our Jeeps Radiator. 3:35 How to Drain Radiator when the drain plug does not work. 4:30 Checking the water pump on our jeep for play. 4:56 How to taking of the Power Steering Pump and Bracket for our Jeep. 5:45 Removing all coolant hoses and explaining why Antifreeze is important. 6:07 How to remove the Water Pump on our Jeep. 6:50 Inspecting the coolant water pump to determine the issue. 7:41 How to clean up the water pump and engine block gasket surfaces than put the gasket on. 8:20 How to put the water pump back on and tightening the bolts 9:09 How to install Power Steering Pump brack and the Pump. 11:58 How to put all the coolant and heater hoses back on for our Jeep. 13:22 How to put the serpentine belt back on the engine for our Jeep Wrangler 14:38 How to put the mechanical radiator fan and fan shroud on our Jeeps Radiator. 15:27 How to tighten an engine belt and not burn up all your engine accessories.