How to install a body lift most of the time is not that hard. Most of the time the hardest part is breaking the bolts loose on the factory mounts. We are actually dropping our body down from a 3 to one inch, we know that sounds weird to a few, A body lift does …
How we installed the Rough Country 4-Inch Suspension Lift Kit with Shocks on the rear of our jeep. Since there are no steering components on the rear suspension so the installations was a breeze! We did have a few human errors during the install, but we hope you learn from our mistakes and your Rough …
Install Rough Country 4-Inch Lift Kit “Rear Only” || Jeep Mods E41 Read More »
How we installed the Rough Country 4-Inch Suspension Lift Kit with Shocks on the front of our jeep. The front suspension lift on any car is going to be the hardest, yes it’s because the front has the steering components. Stay till the end of the video where we give our thoughts on this Rough …
Install Rough Country 4-Inch Lift Kit “Front Only” || Jeep Mods E39 Read More »
Got a Rough Country Winch installed on our jeep and we show you how we did it. This 9500lb Pro Rough country winch was easy to install, most of the work was done by our son, complaining supplied by his friend. Installation of the 9500lb Pro Winch would have only been a couple hours if …
How To Install Rough Country Winch 9500lb Pro || Jeep Mods E38 Read More »
Well, we lifted our jeep, now how-to fix the shifting after we drop our transfer case drop with a body lift. After our lift we could not shift into 4 low, nor could we shift in 2nd, 4th, and reverse. It doesn’t take much money to fix this, but getting the shifter out to modify …
How To Fix Shifter After Transfer Case Drop Or Body Lift || Jeep Mods E36 Read More »
How we pulled our seized on Pitman Arm when just a Puller and PB Blaster won’t work. In this ho to, we pull a rusted-on pitman arm off our old jeep to correct the steering for a 4-inch lift kit we are installing. Tools and parts: Conical Pitman Arm Puller: https://amzn.to/39xiTFo Milwaukee 18-Volt Drill and …
How we installed a Barricade Trail Force bumper with LED lights on our Jeep. The instructions for this bumper had to be the worst I have seen in a while, with the wiring not even included. If you have any mechanical skills you probably would not even look at instructions, I know we didn’t, but …
How To Install Bumper With LED Lights || Jeep Mods E35 Read More »
We go over how to replace the IAC valve and the symptoms we saw that prompted us to change it. I know in the last sputtering episode we said it was the sparkplug, well it was, this issue came on over a month later. If you have a problem with your IAC valve it will …
How To Replace IAC Valve || Jeep Sputtering Fixed E11 Read More »
How we Isolate a Cylinder Issue by unplugging each injector on a TPI fuel rail. This is a great way to narrow an issue to one cylinder that may have issues like our sputtering jeep issue. Now that we found our issue with our Jeep Wrangler, we do the sparkplug change and gaping the plug. …
How To Isolate Each Cylinder For TPI Engine || Jeep Sputtering Fixed E10 Read More »
Compression is key to good performance How to test engine compression and the tools used to do it. The reason for us doing the compression test was, the jeep is running bad and we thought we had replaced all other parts that could be the cause of our symptoms. Look at our jeep playlist for …
How To Test Engine Compression || Jeep Sputtering E09 Read More »
